First of all, you must wear gloves when installing the cloth wardrobe to prevent scratches during installation. Before installation, be sure to read the manual carefully. This is because the cloth wardrobe is mainly connected by connecting pipes and connecting pieces. Just find the corresponding connecting pipes and baffles, plus the instructions, and it is very convenient to install.
The first step is to install the bottom first
(1) First install the middle one at the bottom of the cloth closet, take out the four-way joint with the bottom and high, and connect the middle with a short pipe.
(2). Install a four-way joint on each side, and then install the tube. When installing the tube, decide where to put it, and install the long tube while installing the short tube.
(3). Then install the base cloth on both sides at the same time, and install a tee joint on each side.
The second step, set the wardrobe cloth cover
(1) After installing the bottom, insert six short steel pipes, and then put the whole wardrobe cloth on the surrounding holes.
(2) Install another layer of partitions like the bottom, and cover the six steel pipes.
The third step is to install the short-side floor
If it is a cloth wardrobe divided on both sides, install the floor with the short side first.
(1) Insert the side steel pipe and install the spacer.
(2) Connect the four-way joints, and then install two horizontal steel pipes, and then install spacers to make up the four-way joints on both sides.
(3) Repeat to install the partition until it reaches the top layer.
The fourth step is to install the long side of the steel pipe
(1) After the short side partition is installed, the long side is a vertical clothes hanging area.
(2) Connect two long pipes with a three-way joint in the middle to the top.
The fifth step, install the top steel pipe
(1) After both sides are installed, connect them directly with long steel pipes, so that the wardrobe is installed.
(2) If the wardrobe is too high to be squeezed, it is recommended to push it sideways to avoid not being installed properly.
(3) At the same time, install the clothes-hanging steel pipe with a hook-type joint.
The sixth step, set the wardrobe cloth cover
(1) Pull the bottom to the top when the big sleeve is above, so that there is room for pulling at the top.
(2). Until the upper corner is installed diagonally, you can pull the cloth cover down until it is smooth and wrinkle-free.
Here, the cloth wardrobe is installed, and the zipper is unzipped. The cloth wardrobe "is small but complete with all internal organs". Collect the clothes you don't use for the time being, and give yourself a clean and cozy nest.
Disclaimer: The above content comes from the Internet and does not represent the views of this site. I hope some of the content can help everyone.
We (Alice) are a professional manufacturer of bedroom furniture nameplates. We have 21 years of experience in furniture label making. We can produce zinc alloy, aluminum, stainless steel, copper, brass, pvc and other different labels.
Contact us E-mail: firstname.lastname@example.org